I'm looking for following parts for my operation,
Part #1,
1) 1 1/2" (length) by 5/16" (diameter) 303 Stainless Steel
2) Drilled through - using #29 bit
3) end should have a slight tapered, but perfectly flat is fine also (as long as edge is not jagged, need to be smooth as it will be pressed into another parts)
4) 1/3" knurled on one end with slight groove.
Part #2
1) 1/2" (length) by 3/8" (diameter) 303 Stainless Steel
2) Drilled through using #29 bit
3) Drilled on center using #29 bit
4) Tapped both holes for 8/32 thread
This is for continuing run with no end date and minimum of 200-400 pieces per order with annual consumption of 3-5000 pieces annually.
Attached is a crude drawing of the part (picture/part could be forwarded).
Part #1,
1) 1 1/2" (length) by 5/16" (diameter) 303 Stainless Steel
2) Drilled through - using #29 bit
3) end should have a slight tapered, but perfectly flat is fine also (as long as edge is not jagged, need to be smooth as it will be pressed into another parts)
4) 1/3" knurled on one end with slight groove.
Part #2
1) 1/2" (length) by 3/8" (diameter) 303 Stainless Steel
2) Drilled through using #29 bit
3) Drilled on center using #29 bit
4) Tapped both holes for 8/32 thread
This is for continuing run with no end date and minimum of 200-400 pieces per order with annual consumption of 3-5000 pieces annually.
Attached is a crude drawing of the part (picture/part could be forwarded).
Attachments
Last edited: