Request For Quote- Small quantity job, 1/16" or 1/8" Aluminum plates with perforations, rounded corners

Status
Not open for further replies.

Jonny Quest

New Member
Al Plate.jpg

Would like 2 sets (4 pieces total) of the attached.

6061 Aluminum preferred, also willing to do 6063 or 5052 depending on price.

Brushed finish with either no or clear anodizing.

Payment by Credit.

Would prefer delivery within the next 3-4 weeks.



Located near Atlanta, GA.

Email at straw_ewe [at] hotmail
 

Attachments

  • Al Plate.pdf
    120.7 KB · Views: 28
  • Al Plate.DXF
    355.3 KB · Views: 7
Last edited:

integymachine

New Member
That many significant digits are a little intimidating on a sheet part, What are the tolerances? I would also like to know if there a preference in grain direction for the brushed finish ? thanks.
 

Jonny Quest

New Member
For the dimensional cuts within 0.05" is fine.

For the holes due to that tight pattern (which I'm flexible on, these are ventilation holes) we're in the 0.005" arena.

If the 1/8" holes are too worrisome, I'm willing to do 3/16" on a similar pattern.

Brushed finish would be horizontal according to the drawing. However I'm leaning towards a plain (or clear anodized) finish.

Thanks, much!
 
Status
Not open for further replies.
Top