skylargray
New Member
Greetings everyone,
I am in need of a milled Aluminum 6061 part.
The part is a pushbutton switch actuator.
See linked PDF for details.
Quantity: 10, 20
Tolerance: ±.002"
Finish: mill / clear anodize
Timeframe: flexible
I would like quotes for 10 of these parts with mill finish, 10 with clear anodize, 20 with mill finish, 20 with clear anodize.
As we are in the prototyping stage, we need only 10-20 now.
Also, we are not in a super rush, so we can accept longer lead times if the price is right.
When we're ready for production we will need 5000-5500 (with anodize), so this could lead to a bigger job.
SolidWorks, IGES, and STEP formats are in the linked zip below. If you need a different format, have problems opening what's attached, or have questions, please do not hesitate to contact me.
Thank you for your time,
~Skylar Gray
~Equinox Systems
~skylarra@hotmail.com
www.equinoxsystems.net/RFQ/EqFS06_actuator_20080801.zip
www.equinoxsystems.net/RFQ/EqFS06_actuator_20080801.pdf
As an added note:
The square, blind hole in the bottom of this part can have radiused corners for ease of fabrication.
The smaller the radius, the better; I would prefer no larger than 0.039" (1mm) radii.
I am in need of a milled Aluminum 6061 part.
The part is a pushbutton switch actuator.
See linked PDF for details.
Quantity: 10, 20
Tolerance: ±.002"
Finish: mill / clear anodize
Timeframe: flexible
I would like quotes for 10 of these parts with mill finish, 10 with clear anodize, 20 with mill finish, 20 with clear anodize.
As we are in the prototyping stage, we need only 10-20 now.
Also, we are not in a super rush, so we can accept longer lead times if the price is right.
When we're ready for production we will need 5000-5500 (with anodize), so this could lead to a bigger job.
SolidWorks, IGES, and STEP formats are in the linked zip below. If you need a different format, have problems opening what's attached, or have questions, please do not hesitate to contact me.
Thank you for your time,
~Skylar Gray
~Equinox Systems
~skylarra@hotmail.com
www.equinoxsystems.net/RFQ/EqFS06_actuator_20080801.zip
www.equinoxsystems.net/RFQ/EqFS06_actuator_20080801.pdf
As an added note:
The square, blind hole in the bottom of this part can have radiused corners for ease of fabrication.
The smaller the radius, the better; I would prefer no larger than 0.039" (1mm) radii.
Last edited: