1) Material type: 0.05 - 0.07 inches thick stainless steel or about 0.125" thick aluminum.
2) Unless local (riverside, CA) please indicate material cost in quote.
3) Quantity: 100 for first batch.
4) Drawings should be immediately available or necessary specs.
Will provide drawing shortly but here is quick spec:
It will be recatangle pieces with about 4 inches by 3 inches.
14 holes in there total for m4 tapping (quote without and with m4 tapping would be nice to have).
5) Required time frame: 2 weeks once job starts.
6) RFQ ending time: Will take on quotes for 2 weeks.
7) Full contact information should be supplied upon first contact by email from both parties, neither should have to reply to @.com
Reason I have left the thickness not absolute is while it is better to be thicker (not more than 1/8") I am worried about waste of maching time & feasabilty of such endeavour.
Depending on how things goes, this job might get repeat orders down the line.
2) Unless local (riverside, CA) please indicate material cost in quote.
3) Quantity: 100 for first batch.
4) Drawings should be immediately available or necessary specs.
Will provide drawing shortly but here is quick spec:
It will be recatangle pieces with about 4 inches by 3 inches.
14 holes in there total for m4 tapping (quote without and with m4 tapping would be nice to have).
5) Required time frame: 2 weeks once job starts.
6) RFQ ending time: Will take on quotes for 2 weeks.
7) Full contact information should be supplied upon first contact by email from both parties, neither should have to reply to @.com
Reason I have left the thickness not absolute is while it is better to be thicker (not more than 1/8") I am worried about waste of maching time & feasabilty of such endeavour.
Depending on how things goes, this job might get repeat orders down the line.
