Need tooling for press operation to form clips. The tooling will be used for short run prototyping thus I am not looking to invest to much money.
Not sure but the use of EDM equipment may be a plus. Material should be S7 tool steel.
There are two sets needed both very similar. I have attached one for review. I would also consider just edm blanks If you don't have the time to drill and tap the holes. I can finish them and heat treat them here if needed.
I can also provide files in iges or dwg. 3d. if needed.
Thanks, Ray S
Not sure but the use of EDM equipment may be a plus. Material should be S7 tool steel.
There are two sets needed both very similar. I have attached one for review. I would also consider just edm blanks If you don't have the time to drill and tap the holes. I can finish them and heat treat them here if needed.
I can also provide files in iges or dwg. 3d. if needed.
Thanks, Ray S