jrobson1
New Member
Not sure if this is the right place.
Looking for someone that can provide a quote on a prototype BT30 holder (OD grinding on outside of taper as well as on a straight bit) and Shrink fit section (OD and ID grinding)
I'll provide the turned and heat treated blanks, just need the grinding done. Drop me a pm and I'll send the drawings.
Regards,
Jonathan.
Looking for someone that can provide a quote on a prototype BT30 holder (OD grinding on outside of taper as well as on a straight bit) and Shrink fit section (OD and ID grinding)
I'll provide the turned and heat treated blanks, just need the grinding done. Drop me a pm and I'll send the drawings.
Regards,
Jonathan.