1.5 O.D 3 length 10 or 20 pc

Status
Not open for further replies.
E

erd39030

Maquinados CNC
Is the tolerance of the ID for the bearing right?

Normally it is +/- 0.0003 (in the tenths, not in tousandths) so the bearing is hold tight without being deformed for excessive wall pressure.

I can give you a good price, but I don't want to start a war of prices here
how do I send private messages here? there is a subscription fee or something?

Best regards:
Everardo Rascon
erd39030@hotmail.com
 
E

erd39030

Maquinados CNC
Hi

At a rate of $45/hr, I offered him $6.5 per part with closer tolerances in the bearing chamber.

Thx Plasmaplasma :D
 
P

plasmaplasma

New Member
MSG for Evorado

I am tring to send email to you and I am getting messages that my email was rejected because of my IP address. But I've tried from 3 different computers:
home, work and internetcafe.

Something is wrong with your email provider, I guess
 
E

erd39030

Maquinados CNC
Hi, PlazmaCAM

I just sent you an email with my other email addresses, to see if the problem is with hotmail or with my ISP

The last email I received from you was yesterday, about USPS using donkeys.

It appears that the money order finally arrived.
I will ship your job next week.

Thank you:
Everardo Rascon
 
Status
Not open for further replies.
Top