I'm looking for a reasonable price for these 5 units. these are for testing of the design... the final production will be done by extrusion followed by finish machining the bottom hole. You'll notice the drill hole has a flat/square bottom... the intent was for this hole to be cut by plunging a 31/64" endmill. Be sure that the threads are as deep as the bottoming tap will allow. The center hole will house a rubber bushing so it should be smooth to prevent abrasion. I called out 32 RMS as a rough estimate... I just want clean cuts from a rigid tool with any chatter kept to a minimum. I've also called out "matte black anodizing" in the drawing... if you have this capability, please quote with and without anodizing. If not, quote the job "as machined". Either way, be sure to indicate which is quoted.
Thank you for your time and attention!
1) Material type
6061-T6
2) Is a material quote required or is material supplied.
Quote required
3) Quantity
Five (5)
4) Drawings should be immediately available or necessary specs.
.IGES available on request - PDF drawing attached to this post
5) Required time frame
4 week delivery
6) RFQ ending time
One week (I will extend if needed)
9) Make known any special treatments/finishes not necessarily related to the machining process.
Please quote as machined and anodized matte black if you are able to provide this service
Thank you for your time and attention!
1) Material type
6061-T6
2) Is a material quote required or is material supplied.
Quote required
3) Quantity
Five (5)
4) Drawings should be immediately available or necessary specs.
.IGES available on request - PDF drawing attached to this post
5) Required time frame
4 week delivery
6) RFQ ending time
One week (I will extend if needed)
9) Make known any special treatments/finishes not necessarily related to the machining process.
Please quote as machined and anodized matte black if you are able to provide this service