Hello,
I am looking to have 100 - 200 of these pieces made. The 16 surface finish is not mandatory, but the surface needs to be as smooth as reasonably possible.
We have made many of these already, so good Mastercam files can be provided to lower the cost. We used .5 x .625 6061 aluminum bar cut to length.
Thanks,
- Andrew
I am looking to have 100 - 200 of these pieces made. The 16 surface finish is not mandatory, but the surface needs to be as smooth as reasonably possible.
We have made many of these already, so good Mastercam files can be provided to lower the cost. We used .5 x .625 6061 aluminum bar cut to length.
Thanks,
- Andrew