GHB
New Member
1) Delrin plastic rod
2) I will ship the material to your shop at my cost
3) 10-20 at first depending on price
4) I'd like to receive these pieces about 2 weeks after i ship out the material.
5) August 14th 2009
6) Im going to polish these pieces so i'd like a surface finish that will help facilitate that. I feel that plus or minus 0.015 of an inch is an acceptable tolerance but if you feel it will add considerable cost im open for looser tolerances (but im pretty sure this should not be a problem for most cnc lathes). The hole in the center can be anything from 0.25 to 0.315, its just going to be a pilot hole.
Thank you for your time. Feel free to ask any questions
2) I will ship the material to your shop at my cost
3) 10-20 at first depending on price
4) I'd like to receive these pieces about 2 weeks after i ship out the material.
5) August 14th 2009
6) Im going to polish these pieces so i'd like a surface finish that will help facilitate that. I feel that plus or minus 0.015 of an inch is an acceptable tolerance but if you feel it will add considerable cost im open for looser tolerances (but im pretty sure this should not be a problem for most cnc lathes). The hole in the center can be anything from 0.25 to 0.315, its just going to be a pilot hole.
Thank you for your time. Feel free to ask any questions
Attachments
Last edited: