Manifold,Coupler and fuel tees

[lavrgs]

5 parts and I would like quotes for 3,6 and 10 sets
1 set is 3 manifolds, 3 couplers, 1 ea of the 2 fuel tees
Material is 6061 T6
Finish will be anodized but I can get it done.
Attached file has IGES data but I can provide whatever you need.

I would prefer a shop near Portland OR

I updated the files to pdf - these are not fully dimensioned drawings but hopefully give enough information for a quote.

I did not state in my original post that these parts are currently at a shop but they have been slow and I need a Plan B

 

[drylakemachine]

fuel manifolds

Hi I am interested in quoting your part's Are the prints available in PDF format? If so please send to jamesmustaikis@yahoo.com or attach to the thread.
Thank you Jim.
Dry Lake Machine
El Mirage Ca.

 

[bobk]

Please, attach a different file format prefferrably a PDF or DXF ect.
Zip files are a pain!

 

[besc]

I have the same request. I imported your IGES files but all they are is line models. What really works for me is STEP format. But from what I can see so far looks like fun. My web site is http://www.conceptualmachining.com My email is mike@conceptualmachining.com

Look forward to hearing from you. Thanks. Mike.

 

[lavrgs]

updated files

I updated the files in my original post to pdf. These are not fully dimensioned prints but should give enough info for a quote. This is my first time using this site and I appreciate not being beaten up too badly for my exclusions.
As far as step files go, is wireframe or surfaced preferred. I know there's a huge difference in size between the two.

 

[lavrgs]

Adding STEP Files

If Surfaced files are required I will most likely have to send them off line...looks like stp files aren't allowed