Custom Gauge Pin Set?

[CreationsUnlimited]

Saw the other guy post up so I figure i'd post mine too. I need quality pins so I'm willing to pay for quality. Going to be using these a lot for a job I have where the OD ring has to be .9915 +/- .0005.

Need .9910 - .9920 by the .0001th.
Stainless Steel (304)
Break all sharp edges and mark them somehow so they don't come off.

Thanks

 

[beege]

Give these people a buzz. Some of their staff came over from Van Keuren

http://www.bostoncenterless.com/pingage.htm

 

[CreationsUnlimited]

I forgot to mention...I need a .375"(+-.020 just for clearance) hole in the middle of each gauge plug due to the fact of a cone sticking up in between the ring I need to measure ( no tolerance on ...I made some plugs out of aluminum but they are already galled after using for 2 jobs and just dont have time to mess with this right now.

 

[Dualkit]

You are under an inch, they should be available off the shelf, try these people:
http://www.deltronic.com/