rpcelectronics
New Member
I have a small job that I need to have done in the next few weeks. The product uses a standard Pactec ABS plastic case. Two halves, with a removable end panel. The milling requires one of the halves and the end panel to be milled.
This is a first run, with the potential for more, if the product takes off.
I have .dwg and .dxf files drawn up. They may need to be tweaked before milling. I am willing to make those changes to the drawing, but they should be enough to quote the job. The .dxf files are attached, I can provide the .dwg files, if needed.
We will provide the cases.
I can be directly contacted at jason (at) rpc-electronics.com
Thanks!
Jason Rausch
RPC Electronics, LLC
www.rpc-electronics.com
This is a first run, with the potential for more, if the product takes off.
I have .dwg and .dxf files drawn up. They may need to be tweaked before milling. I am willing to make those changes to the drawing, but they should be enough to quote the job. The .dxf files are attached, I can provide the .dwg files, if needed.
We will provide the cases.
I can be directly contacted at jason (at) rpc-electronics.com
Thanks!
Jason Rausch
RPC Electronics, LLC
www.rpc-electronics.com