I need 200 of these machined from aluminum 6061.
I can provide a DXF of the print and a 3d model if needed. Until then, there's a print of the workpiece attached below. The print shows the only toleranced features, the other features are simply as-programmed.
Thanks!
I need 600 quantity of circular lenses cut out from 1/16" thick lexan or polycarb.
The diameter is 1.430 inch, with a tolerance of 0.006" (limits 1.418" to 1.442")
Tabs are acceptable...I'll just sand them off if they're left on.
The components are for an optical application so I'd like...
Hello, I have a reasonably simple lathe component that I need turned. Attached below is a print with tolerances.
The material is aluminum. I'm looking for 100 quantity.
One important note - the workpiece doesn't even need to be deburred after it comes off the machine. Even if there's a...