I need a male DB9 (http://en.wikipedia.org/wiki/DE-9_connector#DE-9_connector) soldered to a male DB25 with the attached picture in mind.
using pictures and colors attached:
red, db9: pin 5, db25: ground/shield/exterior
black, db9: pin 1, db25: pin 7
green, db9: pin 3, db25: pin 23...
This is by far the best place to RFQ for a job like this . . . thank you for all that have placed a quote but this job has been filled. I look forward to working with rfqwork.com again. I will take this post down as soon as I figure out how to do that and if I am able.
de-burr any method you like (file, sandpaper, steel wool) to achieve 125 micro inch or better by visual inspection (no profilometer needed) Stock 3/4" OD acceptable, no OD turning will be needed and saw tooth striations left on are acceptable.
qty will be 700/qtr.
using similar to McMaster-Carr 8554K3 3/4" Black "MDS-FILLED Nylon 6/6 Rod 3/4" Diameter, Opaque Black" cut to 4" long ±.050 with a 1/8" diameter hole at the center 2"±.050 from end perpendicual to axis of dowel. Chamfer 1/8" diameter hole. Chamfer ends .060"±.020 x...