Request For Quote- Small Parts Milling

Status
Not open for further replies.
R

rpcelectronics

New Member
I need a quote to have the attached design milled. These are small aluminum end panels for a few preliminary prototypes. If we get the job on our end, there is a potential for a job of 1000-2000 pcs.

Ability to engrave simple labeling would be a plus!

Please send quotes to jason@rpc-electronics.com

Thanks!
 

Attachments

  • rtrak-hp panel milling.jpg
    rtrak-hp panel milling.jpg
    55.7 KB · Views: 193
F

F&F

New Member
What is the thickness of material and tolerences? I take it the holes and pockets are thru.
 
R

rpcelectronics

New Member
F&F said:
What is the thickness of material and tolerences? I take it the holes and pockets are thru.
Click to expand...

Thickness = 1.5 mm

Tolerance is about 0.5mm. I oversized the hole specs a bit to make up for the fact that the connectors that will come through these holes can vary slightly in their alignment.

All of the holes are through, nothing special.

Also, a few others have asked about anodizing. Not required. These parts are simple aluminum end plates with a clear finish. Since these are for prototypes, there is no need to re-coat.

Thanks!
 
R

rpcelectronics

New Member
I want to thank everyone who has submitted quotes to us, for this job. We are reviewing them and will be in touch shortly. Regardless, we will give you a yes or no so we don't leave anyone hanging out to dry.

I am keeping a list of names for future jobs as well. Everyone has been very helpful and direct.

Thanks!
Jason
RPC Electronics, LLC
www.rpc-electronics.com
 
Status
Not open for further replies.
Top