[closed] Quick Turn One-off Machined Plastic Parts - Updated 28 Feb

Status
Not open for further replies.

mklod

Member
Hello, please quote single quantity of each attached part.

I need these parts to ship in the next 7-10 days.
Hard deadline to ship parts is 28 February 2018.

Quotes accepted until 27 Feb 2018.

Material is POM or delrin. Any fairly rigid plastic should be OK. You will supply material. We don't care about color.

No special finish required. These parts are for test-fitting purposes before we do a large run.

Please email me directly for 3D files: mike at gramresearch dot com
 

Attachments

  • FLOAT END.png
    FLOAT END.png
    65.2 KB · Views: 26
  • CARRIAGE.png
    CARRIAGE.png
    106.4 KB · Views: 23
  • SYRINGE MOUNT BASE.png
    SYRINGE MOUNT BASE.png
    108.5 KB · Views: 23
Last edited:

Chris Abbott

New Member
Hello, please quote single quantity of each attached part.

I need these parts to ship in the next 7-10 days.
Hard deadline to ship parts is 24 February 2018.

Quotes accepted until 22 Feb 2018.

Material is POM or delrin. Any fairly rigid plastic should be OK. You will supply material. We don't care about color.

No special finish required. These parts are for test-fitting purposes before we do a large run.

Please email me directly for 3D files: mike at gramresearch dot com

Do you have the cad? Email it to sales@poorboytactical.com
 

stustev

New Member
Just signed up and see this is past due. Have the parts been delivered? If not, do you have sol models?
 
Status
Not open for further replies.
Top