terror_storm
New Member
Hello,
I am interested in getting a quote on producing the following part. I am unsure of the quantity that will be required. Initially I will require only two them. These are brackets that will be used to adapt from rear drum brakes to disc brakes on a ~2,300lb car. That being said, I don't know what thickness or type of steel to use for this application. My "gut feeling" says that 5/16" or 3/8" thick should be sufficient. I have included a pair of images below, as well as a .dxf of the part.
If you have any questions feel free to ask!
Thanks!
Jeremy
I am interested in getting a quote on producing the following part. I am unsure of the quantity that will be required. Initially I will require only two them. These are brackets that will be used to adapt from rear drum brakes to disc brakes on a ~2,300lb car. That being said, I don't know what thickness or type of steel to use for this application. My "gut feeling" says that 5/16" or 3/8" thick should be sufficient. I have included a pair of images below, as well as a .dxf of the part.
If you have any questions feel free to ask!
Thanks!
Jeremy