Rfq - Wooden Prototype - Houston, Tx

Status
Not open for further replies.

David Hanks

New Member
I'm wanting to make a couple parts for a wooden kaleidoscope I'm working on.

The two parts are attached. They're fairly simple, but will require a couple setups each. I'd like to work with someone to make these first run out of oak. A final run would be on some oak that I supply. A local shop would be idea, but not necessary.

I'm welcome to any suggestions to making this more manufacturable.

Material: oak
OD: 2.5 in
ID: varies .9" to 1.638"
 

Attachments

  • SimpleWood_Scope_2016-Jul-29.png
    SimpleWood_Scope_2016-Jul-29.png
    707.6 KB · Views: 55
  • cross-section.png
    cross-section.png
    143.5 KB · Views: 59

David Hanks

New Member
I've redone this to get rid of the more difficult cuts. Now each piece should be able to be cut with one setup.
 

Attachments

  • crossSection.png
    crossSection.png
    281.3 KB · Views: 13

Hans

New Member
Hi David Hanks:
Thanks for your RFQ. Could you please send your 3D model and files to hans@baide-cnc.com
We'd like to check and reply later after confirmed.
Attached are wood parts we made for your check.
Thank you
Hans
www.baid-cnc.com
 

Attachments

  • 4.jpg
    4.jpg
    36 KB · Views: 9
Status
Not open for further replies.
Top