Awarded Quote Qty20 Polycarbonate Plastic Parts - Closes 10/15

Discussion in 'Milling and Turning Work' started by rfqjon, Sep 21, 2020.

Thread Status:
Not open for further replies.
  1. rfqjon

    rfqjon
    New Member
    Thank you for your review of this RFQ:
    1) Material type is Makrolon Polycarbonate Plastic - http://www.plastics.bayer.com/en/Products/Makrolon.aspx
    2) I will provide the stock material (12"x10"x.495")
    3) Quantity requested in quote is 20 - this work will re-occur occasionally
    4) Drawings/Prints located at: https://drive.google.com/drive/folders/0ByZgsecbYqQ7NWJjNnluU2kxT1U?usp=sharing
    5) 2 Week Turnaround requested for parts – not INCL shipping time
    6) Quotes must be received by 10/15/2020
    7) Parts profile cut from ~.5” stock from supplier – finishing to the .495” tolerances thickness is not required (as shown in document).
    8) Chamfer can be manually applied – limiting sharp edges is what matters most

    The link to drawings above contains PDF, DWG, STL, IGES parts.
    I’ve had success on RFQWORK getting parts completed in the past, and I hope to do the same this time.

    Please contact me if you need clarifications, or a drawing format that is not currently posted.
     
  2. Chad

    Chad
    New Member
     
  3. José baca

    José baca
    New Member
    2
    0
    1
    Mexico
     
  4. José baca

    José baca
    New Member
    2
    0
    1
    Mexico
Thread Status:
Not open for further replies.

Share This Page