Punch & die set needed

Status
Not open for further replies.

rsecret

New Member
Need tooling for press operation to form clips. The tooling will be used for short run prototyping thus I am not looking to invest to much money.

Not sure but the use of EDM equipment may be a plus. Material should be S7 tool steel.

There are two sets needed both very similar. I have attached one for review. I would also consider just edm blanks If you don't have the time to drill and tap the holes. I can finish them and heat treat them here if needed.

I can also provide files in iges or dwg. 3d. if needed.

Thanks, Ray S
 

Attachments

  • clip_punch_2.pdf
    30.5 KB · Views: 90
Status
Not open for further replies.
Top