jmomathews
New Member
Hello everyone,
I need 20 small pulleys turned out of steel. The stock is really no big deal, 4130 or similar is fine. Tolerances are not a big deal but the bore should be slightly plus as it will be sliding over a shaft (Not Press Fit). I don't know what a reasonable tolerance for such would be. If possible could I get a quote for the part as is and also a quote for the part with a #6-32 hole tapped through the groove to the bore for a setscrew.
Thank you for your time,
-Justin Mathews
I need 20 small pulleys turned out of steel. The stock is really no big deal, 4130 or similar is fine. Tolerances are not a big deal but the bore should be slightly plus as it will be sliding over a shaft (Not Press Fit). I don't know what a reasonable tolerance for such would be. If possible could I get a quote for the part as is and also a quote for the part with a #6-32 hole tapped through the groove to the bore for a setscrew.
Thank you for your time,
-Justin Mathews