Small Job Quote Needed EDM Double Keyway

[glbreil]

I am needing some double keyways cut in 17-4PH. The stock is 1.5" round bar 8" long. I need from two to four cuts depending on cost. There is a drawing attached. I have the material and have prebored a wire hole in the center of the stock.

Questions can be directed to glbreil@mvn.net or I can be reached directly at 479-633-5795.

 

[cornova770]

Sent message to your email.

 

[glbreil]

Thanks for the responses. I don't want to waste anymore of your time. I have a couple of quotes that I am considering, however I am also exploring some other possibilities because the cost is considerably greater than I anticipated.

Thanks Gary