Request For Quote- Cutting of 0.06 in aluminum

Status
Not open for further replies.
V

vex

New Member
I'm looking for some quotes for different production runs of the following set; each set must consist of the following:

1 x Front plate
1 x Rear plate
2 x Side S-Clamps
2 x Lower S-Clamps

and I would like to see quotes for runs of 5, 10, 15, and 20 sets. The attached dxf files provide further details concerning the above.

(Please send quotes via PM)

Thanks for looking!
 

Attachments

  • Lower S-Clamp..dxf
    177.4 KB · Views: 39
  • Side S-Clamp..dxf
    172.5 KB · Views: 15
  • Front Plate..dxf
    290.2 KB · Views: 9
  • Rear Plate..dxf
    258.4 KB · Views: 34
V

vex

New Member
Honestly I have no idea what this would normally cost with materials and machine time on it, which makes me hesitant to just come up with a number out of the air. If you have a rough idea of what you think you could do it for go ahead and shoot me a PM.
 
V

vex

New Member
For those who have yet to send in their quotes: please have them to me by no later than Sunday at midnight.
 
Status
Not open for further replies.
Top