Cnc Plasma 14ga Steel - Prototype

Discussion in 'Laser, Waterjet, and Plasma Work' started by AndrewT, Aug 27, 2018.

Thread Status:
Not open for further replies.
  1. AndrewT

    AndrewT
    New Member
    4
    2
    3
    I have a stand that I am looking to have cut. I do not need it bent. I have step files or dxf files of the blanks that I need.

    I will need two sets cut for fitment verification. After that I will be ordering 10 sets at a time.
    No coating required, only the flat raw metal.

    Attached are some drawings to give an idea of what I am looking for.

    On set includes:
    1001 qty:1
    1002 qty:1
    1003 qty:2

    Please quote for 2 sets and 10 sets.

    Please email or message with any questions.

    Thank you!
     

    Attached Files:

  2. MartonBrothers

    MartonBrothers
    New Member
    8
    0
    1
    I was looking at your drawings I'd suggest laser since you have some small holes and location call outs otherwise I can plasma then finish mill if you'd like. but I think laser is your best bet


    -John
     
  3. AndrewT

    AndrewT
    New Member
    4
    2
    3
    Thank you for the suggestion John.
    Though I would prefer a laser to cut them I am working within a budget and believe a plasma will come at a more realistic cost.
    I do not think milling to finish would be needed however if you would like to quote cutting the parts on your plasma I can send you the dxf files to an email
     
    wv_machinist likes this.
  4. wv_machinist

    wv_machinist
    New Member
    Hello is this RFQ still available for submissions?
     
  5. Mike Schwinn

    Mike Schwinn
    New Member
    1
    0
    1
    Do you have your vendor? Is the bid still open?
    Mike
     
Thread Status:
Not open for further replies.

Share This Page