[closed] 303-ss Bellville Washers (not Punched)

Discussion in 'Milling and Turning Work' started by james Griffith, Sep 16, 2019.

Thread Status:
Not open for further replies.
  1. james Griffith

    james Griffith
    New Member
    7
    0
    1
    [ CLOSED - WE'VE FOUND A GOOD MATCH. THANK YOU FOR BIDDING ]

    We're seeking a quote for Bellville washers made from 303-SS
    15,000 pcs 1/2"
    15,000 pcs 5/8"
    1,500 - 2,000 pcs 11/16" (range is to make quoting easier based on using up a bar)
    1,500 - 2,000 pcs 3/4" (range is to make quoting easier based on using up a bar)

    See attached CW Specs.pdf NOTE the perpendicular center wall and outside wall. Also attached is a profile tool as an idea if it helps. Our current shop is unable to add any new volume. We're growing. Pricing for 303 is at $0.30 ea. It's not a big job but it repeats especially in 12L14 using the same tooling

    These items are historically run on davenport and Brown & Sharpe #2 depending on bar size. If I've listed this under the wrong category please advise

    Please don't hesitate to contact me with any questions. I'd like to make a decision by October 15th

    Thank You
    James Griffith
    jgriffith@pfgp.us
     

    Attached Files:

    Last edited: Sep 24, 2019
  2.  
  3. what are the lead times your trying to accomplish. I would be very interested in doing this for you. Jimmy Sisco, Sisco Precision jimmy@siscoprecision.com
     
  4. james Griffith

    james Griffith
    New Member
    7
    0
    1
    Lead time is easy - if they were ready now we'd pay for them. Otherwise please let me know what your schedule would be. I'm sure it works
     
Thread Status:
Not open for further replies.

Share This Page