Hello,
I need two of these components made up for my model airplane. Cost is of primary concern, timeframe is wide open.
Material is 7075 T6, 3/4" round bar, OD does not need finishing to dim shown on drawing, as is finish on round is ok.
I didn't tolerance the drawing, +/- 10 thou is fine on everything except the location of the 8mm central hole, and the location of the two 4mm outer holes, they should be 5 thou or better. I didn't dimension it that well to consider stackups but I was in a hurry
If you can do this work, please send a quote to
chadnortheast@shaw.ca
Also they will need to be shipped to Calgary, AB Canada.
Thanks,
Chad Northeast
I need two of these components made up for my model airplane. Cost is of primary concern, timeframe is wide open.
Material is 7075 T6, 3/4" round bar, OD does not need finishing to dim shown on drawing, as is finish on round is ok.
I didn't tolerance the drawing, +/- 10 thou is fine on everything except the location of the 8mm central hole, and the location of the two 4mm outer holes, they should be 5 thou or better. I didn't dimension it that well to consider stackups but I was in a hurry
If you can do this work, please send a quote to
chadnortheast@shaw.ca
Also they will need to be shipped to Calgary, AB Canada.
Thanks,
Chad Northeast