10k-1000k Pcs Aluminum 5053 Rings

Discussion in 'Production Mill and Lathe work' started by Ben Veenema, Oct 22, 2019.

Thread Status:
Not open for further replies.
  1. Ben Veenema

    Ben Veenema
    New Member
    Looking for a second supplier for 2, high volume aluminum rings ~1" OD. Looking for turning or stamping quotes. Last years quantities were 70k of each part. Similar parts will likely be given to chosen vendor in the future.
    • Material: Aluminum 5053, Vendor Supplied
    • Finish: Anodize, Flat Black, MIL-A-8625 Type II Class 2
    • Quote in 10k, 50k and 100k volumes (each part)
    • Time frame: Lead time 6 weeks give/take depending on volume, to be ordered in next 6 months
    • RFQ Ending: 11/1/19
    Contact:
    Ben Veenema - McNamara Design
    fastrack@mcnamaradesign.net
     

    Attached Files:

    Last edited: Oct 22, 2019
    Dale, Justin89 and Fred Curran like this.
  2. Hi my name is Dan I am sending you a PM with quote for files listed above
     
  3. Ben Veenema

    Ben Veenema
    New Member
    For those looking to turn these parts from round stock, 5053/5052 is difficult to source in round stock. Wrought (NOT cast) 6061 is also acceptable. More detail below:

    I've had a further conversation with our client on this job. They're purpose for 5052/5053 was to select a low-outgasing grade of aluminum for use in vacuum chambers.

    I've looked into outgasing grades and it looks like most grades of aluminum are acceptable including 2000, 4000, 5000, and 6000 series, as long as they are wrought and NOT cast.
     
  4. I recently sent you a PM to fastrack@mcnamaradesign.net with a quote We Have a very good supplier of material and will be able to make
    parts from just about any type of Aluminium you require I will resend you the quote from DblDDavis4007@aol.com if you have any questions you can contact me at that email I will also leave my cell # in message.
     
  5. Byron JO

    Byron JO
    New Member
    1
    0
    1
    USA
    does this RFQ still opening?
     
  6. itatauct

    itatauct
    New Member
    4
    0
    1
    Italia
    Ciao a tutti vengo dall'italia / itawero
     
Thread Status:
Not open for further replies.

Share This Page