| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
| Milling Work Post your Milling work RFQ in this section. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
03-10-2006, 10:39 AM
|
|||
|
|||
RFQ for small stainless assembly...
I need a quote on the project attached here as a drawing. It needs to be made from 3/8" stainless steel square stock, welded up (those welds should look good or be grinded down), and then the whole piece polished.
The quantities are listed on the drawing. We need them in a three to four week time frame. If you have any questions, please email me at albert@synchro-pm.com Thanks for you time. 
|
|
#2
08-08-2006, 03:41 PM
|
|||
|
|||
stainless steel planters
Do you have req. on the gauge of tubling and the sheetmetal used in building these planters?
thank you Mike Moore Quote:
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small run of stainless | Champion Precision | Laser, Waterjet, and Plasma Work | 3 | 03-10-2006 10:15 PM |
| 240 parts laser cut from 12 ga stainless - vibratory finished. | InspirationToolworks | Laser, Waterjet, and Plasma Work | 1 | 01-31-2006 04:27 PM |
Linear Mode
