I need qty 5 of 1/8" square HSS tool bits (2-3" long, 2.5" seems to be standard) ground down to different heights. The bits need to keep thier hardness, so go easy. They will be used as guage blocks.

I need: .115" .110" .100" .095" .090" (+/- .001")

The other dimension (I'm measuring .122" square on my existing bits) does not need to be ground.

Supplier to supply bits (They are .50 each from Enco).

Thanks!

-Jeff

jeff@inspirationtoolworks.com

Will you send me a picture of one of the bits you are talking about? or the 2005 enco page number? I just want to make sure we are thinking the same.
Thanks,
Neil Slater
neil@slatermachine.com

Enco page 51, part 383-5308.

Thanks!

-Jeff

Would you mind if they were made out of carbide round stock? If so, I could just cut them up out of a 1/8 carbide blank that I already have and you wont have to pay ship me your bits. If they are made out of carbide I will grind you one of each length for $50.00 plus shipping. I need about a week to get them done.
Thanks,
Neil

Unfortuneately, they need to be rectangular in cross section for stability. They have to fit into a slot about .130" wide.

-Jeff

I have selected a vendor.

Thanks!

-Jeff

Jeff.

Have you considered cutting them off on a wire E.D.M.
each would only take a few minutes to cut.

Nope, I didn't think of that. If I do more I will certainly offer that option in the quote.

Thanks for the idea!

-Jeff

$2.00 each shipped