Sirs:

Please quote 1, 2 , or all 3 of the attached parts:

1. A small eccentric axle of free-turning ss or steel, you supply. One end a plain shaft and one end #10-32 UNF - relief cut OK at base and screwdriver or allen hole on end. Small shoulder for bearing clearance. Flange may be on either end of eccentric. There *may* be a shallow spot drill to aid in swaging over the head in assembly (will delete if possible or costly). Pls quote 250, 500, 1000.

2. A similar axle, no eccentric. Pls quote 250, 500, 1000.

3. A plastic wheel of delrin, nylon, or similar rigid plastic, you supply. May machine or mold, and will entertain tooling. Pls quote 250, 500, 1000.

All parts to be part of a standard assembly to be repeated. Manufacturability changes welcome. Will entertain higher quantities for cost savings. Delivery time not critical; RFQ open about 2 weeks, pls. On-time payer.

Gregg Carlson
gregg.carlson@gmail.com
Tulsa, OK

Attached Images

CT-034B.jpg (94.8 KB, 100 views)

Quote sent to your email...
Thanks for the opportunity!

Hello, P M and email have been sent

Thanks Brian
Brian's Machine & Powdercoat

What is the depth and width of the screw slots? Also is the eccentric thread .025 off center? Thanks,.........Bob

Hi! Gregg,

My quotation has been sent to your mail.. please, check it out..

Roi

PM sent with quote!

Yes, offset will be .025. Slot is, say, .040 x .040. I have some quote with hex broach (allen), which is also good and probably easier to machine.

Has this job been awarded?