| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
| Turning Work Post your Lathe Turning RFQ in this section. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
06-22-2007, 03:46 PM
|
|||
|
|||
need turned part .5x5 17-4 stainless 2ods 3ids
I need 1 part made and heat treated, please contact me by email= rlau2007@wowway.com
|
|
#2
06-24-2007, 08:22 PM
|
|||
|
|||
|
Its close to impossible difficult to bore a .250 hole as opposed to reaming it meaning more cost. Now your ID radiuses of 1/64 and .029 incur much expenses, might require sinker EDM after heat treating. Also, could the .308 hole be substituted with .310? Other than that all is doable.
Last edited by Madmachinist; 06-26-2007 at 11:37 AM..
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Turned parts capacity | marto74 | Production Mill and Lathe work | 1 | 07-18-2006 08:36 AM |
| Post #1 of 3, Need several parts turned... | synchro-pm | Turning Work | 4 | 02-21-2006 04:22 PM |
| Post #3 of 3, Need several parts turned... | synchro-pm | Turning Work | 4 | 02-21-2006 04:22 PM |
| Post #2 of 3, Need several parts turned... | synchro-pm | Turning Work | 3 | 02-21-2006 04:21 PM |
Linear Mode
