| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
| Turning Work Post your Lathe Turning RFQ in this section. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
12-18-2005, 04:31 PM
|
||||
|
||||
Aluminum Turning work needed
6 pcs of following part,
OD is 1.25 approx 2.25 long. Bearing bore on 2 sides. Bottom of bores can have slight radius but nothing that would interfere with seatings of bearings. Email me at russw@professorwiz.com with quotes. Thanks, Russ 
__________________
www.professorwiz.com |
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum Pullies Needed | stang5197 | Turning Work | 8 | 03-05-2006 02:49 AM |
| RFQ Aluminum plate work | Cold Fusion | Milling Work | 3 | 12-15-2005 02:18 PM |
Linear Mode
