| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
| EDM Need something burned for a mold? Post your RFQ on this page. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
09-25-2007, 01:53 PM
|
|||
|
|||
RFQ - Simple metric part/cutter
I am shopping? Two differnet size parts
Part - 1 You supply 5 good quality stubby type Cobolt or Micro grain Carbide 4mm end mills (single side 4 flute). Perferably with an imperial shank. Right down the middle you drill (EDM) a 2.00mm hole (tol. +-0.01mm) about 8mm deep from the fluted side, without materially affecting the temper of the cutter. The cutter will be used to plunge cut 1mm deep into brass leaveing a 2mm diameter pin behind. Part 2 Same idea as part one but this time the cutter is two flute Micro grain carbide. The cutter is 3/16" diameter with a 1/16" (-0.001") hole and 1/4" deep. Require 10 of these. This cutter will be used on 303 stainless. The hole depth tolerance is not critical in either case. If the above work out, I will come back regualrly for more. 
|
|
#2
09-26-2007, 08:08 AM
|
|||
|
|||
|
I would contact these guys
http://www.tungstentoolworks.com/
__________________
integratedmechanical.ca
|
|
#3
09-27-2007, 08:38 AM
|
||||
|
||||
|
PM sent 9/27.
Thanks
|
| Sponsored Links |
|
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quote Request- RFQ Simple Plastic Part | SirDodson | Milling Work | 15 | 12-18-2007 10:09 PM |
| Simple alum part. 1 thread, 1 o-ring groove. | aaron p | Turning Work | 7 | 06-27-2007 05:52 PM |
| Simple Part 1 pc, RFQ | amasters | Milling Work | 9 | 06-19-2007 07:53 PM |
| Simple Alum Piece | Cpt.Planet | Milling Work | 8 | 05-17-2007 08:31 PM |
| RFQ Simple Steel Piece | vadimvc | Milling Work | 4 | 05-15-2007 09:05 PM |
Linear Mode
