| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
| Milling Work Post your Milling work RFQ in this section. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
01-12-2006, 01:04 PM
|
|||
|
|||
RFQ - 2 pieces CNC'd aluminum emblem
This is a small job, only two pieces, not very complicated. I'm looking to have an emblem made for my motorcycle tank (one piece on both sides, so two pieces). Here's what I need:
Attached is a JPG (for viewing) and a DWG of the emblem. Specs are: - 5052 Aluminum (or whatever grade you may have around that will work fine), brushed. - 8.5" L x 1.5" W - .25" thick If the design can be almost completely routed out instead of being routed/etched into a rectangular block it would be preferred, but I will listen to whatever opinions you guys have for me... you are the masters! There is more talk about this design HERE. Please take a look and see if this answers any questions you may have. Thanks!!! Last edited by dallas4u; 01-12-2006 at 04:29 PM.. 
|
|
#2
01-13-2006, 01:06 AM
|
|||
|
|||
|
I have an awsome Idea for this. I will send you a PM Fri eve.-Dave
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
