| Check out the new CNCauction site, it's 100% free! Check out CNCzone for more RFQ's CNCzone.com. |
|
|
|
|||||||
| Register | FAQ | Members List | Calendar | Mark Forums Read |
| Milling Work Post your Milling work RFQ in this section. |
|
|
|
 |
|
|
Thread Tools | Display Modes |
|
#1
02-23-2006, 10:14 AM
|
|||
|
|||
RFQ for another complete steel assembly....
Project name: Stanhope Table Base (1 pdf and 2 jpegs)
Here is a project I need quotes on. I need the pieces fabricated and welded, and those welds ground. All pieces must be finished to a "brush" finish, which we achieve with 60 grit, then 80 grit, then red scotch bright, which gives a stainless brush look. However you get that look is fine with us. Additionally, if we would like the quote to include clear gloss powder coating (if you have that resource available) and shipping to 10022. I need quotes for 3 (three) with 12" legs as pictured in drawing, and for 5 (five) with 16" legs (everything else the same as drawing). The male sliding tube that holds the table top does not get powder coated, as this would make it bind. Tell us how long you need to get it done. Please include project name in quote. 
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RFQ for complete steel assembly, milling and turning... | synchro-pm | Milling Work | 4 | 02-23-2006 09:28 AM |
| RFQ for complete steel assembly.... | synchro-pm | Milling Work | 1 | 02-22-2006 02:27 PM |
| RFQ for complete assembly.... | synchro-pm | Milling Work | 2 | 02-21-2006 03:18 PM |
Linear Mode
