Tips for vendors and tips for RFQ writers... - RFQWork.com- Online Quotes from Machine Shops, Fabricators, Molders, Stampers, Casters Forgers and more!

InspirationToolworks · #1 12-20-2005, 08:48 PM

Based upon my experiences, I've written up some notes for both vendors (job shops) and RFQ writers. Please see:

http://jeffalbro.net/cnc/rfqs/

http://jeffalbro.net/cnc/vendors/

I'd love to hear comments and suggestions.

Thanks!

-Jeff

rfqadmin · #2 12-22-2005, 03:52 PM

Thanks for helping this site out with these tips.

Very helpful

rfqadmin · #3 03-06-2006, 09:10 PM

Here is some more tips

http://www.jeffalbro.net/cnc/2d-comparison/

SuperiorMachine · #4 06-04-2007, 03:19 PM

These look really helpful!

I would point out that dial calipers should not be considered acurate closer than .005" and that a good tenths indicating Mic is accurate to within .0001". Of course that depends on the skill of the user...

WIREGUY1 · #5 03-11-2008, 08:03 PM

Thanks Jeff, I found your suggestions helpful.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)