Search results

  1. G

    Request For Quote- Please quote small screw-type parts

    Please quote two small screw-type machine axles in steel. Material is flexible, but should be malleable enough to swage over a bearing. There is a small bearing shoulder that could be omitted and replaced with a shim if there is a cost savings. The threaded end should be threaded to 1/8" of the...
  2. G

    Request For Quote- Special Pulley Stock

    Hi - we are looking to produce custom pulley stock. Essentially, we'd start with a round al. bar at given diameter (we might try a couple sizes) and cut twenty tapered grooves around it. The grooves will be .50 wide at the bottom and .50 deep, with a 50 degree taper - if we change O.D.'s, the...
  3. G

    Request For Quote- Special pulley stock

    Hi - we are looking to produce custom pulley stock. Essentially, we'd start with a round al. bar at given diameter (we might try a couple sizes) and cut twenty tapered grooves around it. The grooves will be .50 wide at the bottom and .50 deep, with a 50 degree taper - if we change O.D.'s, the...
  4. G

    Request For Quote- AL mounting block

    Thanks for quoting - RFQ was closed. Sirs: Please quote the attached aluminum mounting block in quantities 25, 50, 100 or so. This is a new part and quantities may rise if it's successful. Material is 2024 or 6061 1 x 1/2 bar stock; mill finish is OK. Length is not critical; saw...
  5. G

    Request For Quote- RFQ: small axle and plastic wheel

    Sirs: I have inserted my RFQ here as I have one of 3 parts that can be machined or molded from most any rigid plastic with good durability. I would like the bidder to also shoot 1000 parts to start, and quote the steel parts if possible: - - - Please quote 1, 2 , or all 3 of the...
  6. G

    Request For Quote- RFQ: small axle and plastic wheel

    Sirs: Please quote 1, 2 , or all 3 of the attached parts: 1. A small eccentric axle of free-turning ss or steel, you supply. One end a plain shaft and one end #10-32 UNF - relief cut OK at base and screwdriver or allen hole on end. Small shoulder for bearing clearance. Flange may be on...
  7. G

    RFQ: small axle and plastic wheel

    Sirs: Please quote 1, 2 , or all 3 of the attached parts: 1. A small eccentric axle of free-turning ss or steel, you supply. One end a plain shaft and one end #10-32 UNF - relief cut OK at base and screwdriver or allen hole on end. Small shoulder for bearing clearance. Flange may be on...
Top