Recent content by yoshi900

  1. Y

    Small Job Quote Needed small stainless parts - 50 pcs

    need 50 pcs, 304/316 stainless, 1/16" thick (.045"-.070" ok) surface finish doesn't matter, some scratches on surface okay. pdf of part here: www.modadin.com/upload/d4-brkt-c6.pdf can send dxf by email if needed. need quote by end of the week (9/26), need parts within 3 weeks from now. edit...
  2. Y

    Request For Quote- Wire EDM Cutting Needed

    I have two different parts (qty 3 of each) that need to be cut into eight pcs radially. (see attached drawing) Material is A2. To make holding the part easier, it would be okay to cut outward to almost to the edge and leaving a bit of material intact. Then after edm, "break" the part into 8 pcs...
  3. Y

    Spline broach

    Looking for a shop to make a push type spline broach. See attached picture for the part shape. The spline is approx. 0.5" dia. I do not have any print on the part, just the sample parts. As you can see, the final part will have a slot with a bolt to clamp down. The size of the broached spline...
  4. Y

    Request For Quote- Carbon Fiber Flat parts

    approx 12"x12"
  5. Y

    Request For Quote- Carbon Fiber Flat parts

    I am looking for a quote to cut 6 flat parts in 1/8" thick carbon fiber. Please quote qty of: 2 sets ( for testing ) 25 sets 50 sets I can supply material.
  6. Y

    Request For Quote- UHMW Milling Work - 50 pcs

    oops, forgot to close the the thread. Job was actually awarded to a US company thru mfg.com
  7. Y

    Request For Quote- UHMW Milling Work - 50 pcs

    Yes, I can probably get away with 0.125"R on those corners. I will double check.
  8. Y

    Request For Quote- UHMW Milling Work - 50 pcs

    Looking for quote to do 50 pcs of a machined UHMW plastic part. See attached file.
  9. Y

    Request For Quote- Laser or Waterjet

    Thanks to all who have quoted on this RFQ. One of the quote submitted by email was awarded the job.
  10. Y

    Request For Quote- Laser or Waterjet

    Need 4 small parts laser or waterjet cut from 24 or 26 ga stainless steel. 20 pcs for each drawing (total 80 pcs) I can provide material or you can provide if you have some. both 3 series or 4 series stainless are okay. These are used for decorative purpose. I need these pieces by...
Top