Recent content by rkenaley

I've placed several (at least 5) orders from here over the past 2 years

Thank you, will get everyone sent copies, and award quote within 1 week.

Print is attached. Tolerances of +-0.003" desired, but rougher may be OK for the right price. Depending on price may go to 600-800 pieces. Thanks!

My apologies for not closing this - I'm not sure how to! Thank you all for the interest and PMs, I have taken down the information and have some jobs coming up I will contact you for. Thanks to the RFQ community. If a mod wants to close this to avoid clutter and wasting people's time, that's...

Email sent! Cleared my PM box, sorry about that!

still open

I can probably furnish the material, I may even be able to get roughs molded out from a previous job.

I have a somewhat complex mill + lathe part, I am looking for someone with experience and capability to process this in magnesium. Must hold excellent tolerances on the dimaters (0.001") part size is .75" diameter by 4" length, can be cut from bar or rod stock. Part resembles a tube, inner...

Roughly speaking, it is a washer of about .782" OD and .660 ID. I have a SLDPRT, but it doesn't let me upload it here, so I would have to do so from home. Any interested parties can contact me here or via email - lurker27 (at) aol.com

I have a small series of parts requiring simple manual work. if anyone is interested, I will respond to PMs, or can email you directly. Thanks.

Luckily I need more work now, so this thread has proved quite useful!

Thanks all for the outpouring of interest. I will do my best to select within the week.

I have another set of ~8 prototyping jobs, all small lathe parts <1.25" dia <4" length. I'd love to be in contact with anyone with some open machine time for this, getting good prototyping has been difficult for me so I ask that the work is reasonably guaranteed to tolerance if done...

I run a small aftermarket paintball gun parts company. I have several parts that need to be prototyped, and eventually done in runs of 100-500. mostly aluminum and Delrin, tolerances generally +-.002". Parts are all smaller than 1" dia, and shorter than 6 inches. Please advise as to interest. I...

Thanks everyone who replied! I would like to prevent this from going too off course, unless of course Ken, being the moderator, would like to restructure this discussion elsewhere. I have had an awesome experience with RFQW so far, and I hope everyone whom I have contacted can work with me at...