Recent content by G Carlson

This is an ongoing need for us, and we need some now.

Please quote two small screw-type machine axles in steel. Material is flexible, but should be malleable enough to swage over a bearing. There is a small bearing shoulder that could be omitted and replaced with a shim if there is a cost savings. The threaded end should be threaded to 1/8" of the...

Note: ends may be slotted or broached for Allen key at a suitable key size.

Thanks Jim, a radius of .015" is desirable there - on the male corner. Of course, that's going to be imperfect on one tool and 3-4 O.D.'s, but tumbling will ease that edge anyway. The female corner doesn't make any difference.

Yes, it's a special deal - I expect to be making 3 or 4 tries at different O.D.'s. before getting it right. GHC

Dave, Correct, I expect to have to try 3 or so O.D.'s before I get it right, so please quote that. Thanks, Gregg

Hi - we are looking to produce custom pulley stock. Essentially, we'd start with a round al. bar at given diameter (we might try a couple sizes) and cut twenty tapered grooves around it. The grooves will be .50 wide at the bottom and .50 deep, with a 50 degree taper - if we change O.D.'s, the...

Hi - we are looking to produce custom pulley stock. Essentially, we'd start with a round al. bar at given diameter (we might try a couple sizes) and cut twenty tapered grooves around it. The grooves will be .50 wide at the bottom and .50 deep, with a 50 degree taper - if we change O.D.'s, the...

Thanks for quoting - RFQ was closed. Sirs: Please quote the attached aluminum mounting block in quantities 25, 50, 100 or so. This is a new part and quantities may rise if it's successful. Material is 2024 or 6061 1 x 1/2 bar stock; mill finish is OK. Length is not critical; saw...

Please contact me at gregg dot carlson@gmail dot com

Yes, offset will be .025. Slot is, say, .040 x .040. I have some quote with hex broach (allen), which is also good and probably easier to machine.

Hi - I noticed you were over in Gravette - I have inlaws there. I posted these little axles and plastic wheel today - might be too small for your new machine - ? Thanks, Gregg Carlson Sirs: Please quote 1, 2 , or all 3 of the attached parts: 1. A small eccentric axle of free-turning...

Hi - I posted this RFQ with 2 metal axles and one plastic part that could be turned or molded. I would be interested to hear about molding and shooting 1000 parts, per your post - thanks, Gregg - - - Sirs: Please quote 1, 2 , or all 3 of the attached parts: 1. A small eccentric axle...

Sirs: I have inserted my RFQ here as I have one of 3 parts that can be machined or molded from most any rigid plastic with good durability. I would like the bidder to also shoot 1000 parts to start, and quote the steel parts if possible: - - - Please quote 1, 2 , or all 3 of the...

Sirs: Please quote 1, 2 , or all 3 of the attached parts: 1. A small eccentric axle of free-turning ss or steel, you supply. One end a plain shaft and one end #10-32 UNF - relief cut OK at base and screwdriver or allen hole on end. Small shoulder for bearing clearance. Flange may be on...