Forum: Club house

Hi all, I am looking for a reliable painting / powder coating / chemfilm? any leads on a good one. They must be at a minimum ISO ceritfied, prefer...

Hi Guys I have a question. Say you bid on a job and it's accepted, what the standard then? Do you get a portion of the agreed amount up front? Do...

seeing if anyone here is able to mandrel bend some 304ss 16ga? looking to get a quote please email me at BBfabrication@hotmail.com

I need to get some sleeves so that a 1/2 bearing can press onto an 18mm shaft. Resulting in approximately a .75" OD by .71" ID sleeve, approx 2...

I was wondering what the vendor to customer ratio was among the members here. It seems to be out of balance to me. If you are (a buyer)looking for a...

Good morning to all, I just wanted to know which machine from which company, according to you, is the ultimate machining centre that is available...

Any shops out there that I can pay a percentage to and get some work or anyone out there that is weeding out work? If I had to chose between doing...

Hi All! Im the new guy today! As I was signing on I noticed I know a fellow who advertises here: GeckoDrive Well, I use a small Fab Guy...

Hello all, I have a project that I want to prototype. I have completed my first CAD drawing of the design using eMachineShop.com software and...

This is a new frontier for me , can anyone tell me their requirements, I have heard about neading special clearance, for some jobs. How do you get...

I'm in need of someone who has a tube bender that is capable of bending 1.25" or 1.5" OD 6061-T6 Tubing. The wall thickness will be .125". I'm trying...

Hi I need a Mazak Slant Turn 15 Universal electrical wiring Diagram (ladder Diagram). Is there anyone could sell me a copy or original? My...

Any of you out there still running an older Okuma LC-30-2SC w/OSP3000L Control with single line display. We are needing to make a copy of someones...

Help, I am looking for some material which is hard to find, it is a polycarbonate/ABS mix "CYCOLOY C6200", I only need a piece 8" x 8" x 1/2" thick,...

www.ntma.org/EWEB/dynamicpage.aspx?webcode=AboutNTMA I am not promoting it. I really just found it and wondered if any of you had a membership. If...

I know a lot of you are either doing government work or have played with the idea and some would like to learn a little about it so I would like to...

Just came across some information and thought I would ask and see what others were doing. Do you try and source your steel and other raw products...

Hi All, We have on the floor in our shop a Mori SL-2 turning center with a Yasnac control and it seems to be backward in the "X" axis in that it...

Anyone know what they will be for March. Thanks, John